I've been a follower of r/ToolBoxPorn for a while and and I wanted to make my own version - and not just a couple of drawers either. So here goes!
I've had the "main stack" for about fifteen years, it's the automotive equivalent of two Marshall 4x12 cabinets. I got the top box first and I was stoked to be able to afford to buy it at the time.
 |
| Torque wrench, digital calipers, feeler gauges, flashlights |
 |
Pliers, wire cutters, stripers etc.
|
 |
Screwdrivers and standard nut drivers
|
 |
| Standard sockets and extensions (1/4", 3/8" and 1/2" drive) |
 |
| Standard wrenches and ratchet handles |
 |
Metric sockets (1/4", 3/8" and 1/2" drive)
|
 |
| Metric wrenches and nut drivers |
 |
| Yes, a whole drawer just for HAMMERS! |
 |
| Grease guns, engine building tools; bolt/nut sizers |
 |
| pullers and seal drivers, engine lift plate |
 |
| battery charger, dwell/tachometer, inspection lamp, tire repair kit |
The toolboxes below the welding bench are more recent additions:
Left side:
 |
| Sealant, grease, bodywork and trim tools |
 |
| Taps and dies; standard, metric and NPT |
 |
| Electrical wire and cables, tape, cable ties |
 |
| Electrical tools, crimping and cutting pliers; cladding |
 |
| Heat gun, high-speed drill, other power tools |
Right side:
 |
| Clamps, files, welding clamps |
 |
| Wire brushes, soldiering and welding gear |
 |
| Cutting and bending tools, slide hammer |
 |
| Timing light, vacuum test gauge, flexible fuel lines |
 |
| More power tools and some windshield caulk |
No comments:
Post a Comment